VERIFIED
Eight flashes, a pause, four flashes, a pause, and the pattern repeats: that is how Maytag’s help article titles F8 E4. The dishwasher has found water in its drip tray. The technical manual words the same display slightly differently, as an overfill switch that is open, and it also points to excess suds or foam, which wrong or too much detergent can cause.
Check these in order
- Open the drip tray. Squeeze the snaps on its two sides toward the middle and ease the tray toward you. Do not tug, because the float switch wire is still attached to it. Empty out any water.
- Look at the float switch connector. It has to be seated all the way in, and lining it up with its housing and pushing until the locking tab shows over the back does that. Its wire must not rest against the motor or the lower tub.
- Go over each water connection point. The rubber washer should sit properly in the fitting. The 90-degree elbow is tightened by hand first and then checked with pliers. The fill hose leaves through the rear left side of the unit.
- Press Cancel one time to quiet the alarm tone, and a second time to wipe the code.
If a professional installed the dishwasher
On a professionally installed unit the machine begins a drain sequence and will not run. Shut off the water supply, silence the alarm with a single press of Cancel, leave the power switched on and keep the door shut.
Water-supply codes that are easy to confuse
- F8 E5 is a fill valve stuck open.
- F8 E2 is a fill valve electric error.
- F8 E1 is the dishwasher not detecting water.
Maytag dishwasher repair around San Francisco
When F8 E4 keeps returning after the tray and connection checks, the next step is a technician visit anywhere in San Francisco and the Bay Area. Start from the Maytag dishwasher repair page or ring (415) 649-2156. Have the model number, what you found in the drip tray and the connections you inspected ready.
Model compatibility: Maytag reuses codes across series and model years, so F8 E4 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
