Written by
Tessa Brandt Appliance Care EditorPublished October 29, 2026
VERIFIED
Error codeF0 E5
ApplianceWasher
F0 E5 comes from a sizable load that is lopsided in the basket. Spin speed is reduced as a result, so the cycle may run longer than the display suggests and less water gets extracted, which can leave clothes dripping.
If yours is a front load washer
Clothes that are not dripping: the wash finished as it should, and there is nothing to do.
Clothes that are dripping: pull out a few pieces and start “Drain & Spin”. Avoid cramming the basket full.
A lone bulky piece, like a rug or a jeans jacket: wash a few more garments with it so the weight is shared, then run Drain & Spin.
If yours is a top load washer
Stop the cycle by pressing Start, or by pulling the power cord.
With water in the tub, run a drain-only cycle first.
Spread the clothes out or take some away so the load sits level and is not too heavy.
For the adjusted load, Maytag suggests the Bulky or Heavy Duty cycle.
A cycle that can still be paused gives you a shortcut: press Start to pause, lift the lid, adjust the clothes and press Start to resume. Drain & Spin is available afterward if all that remains is water extraction.
Codes that relate
F0 E9 is the out-of-balance code where the washer first tries to correct the load itself.
Maytag washer service for unbalanced loads in San Francisco
When rebalancing does not remove F0 E5, a technician visit is the next move. Call (415) 649-2156 for Maytag washer repair in San Francisco and the Bay Area, with the model number and a list of the steps you tried.
Model compatibility: Maytag reuses codes across series and model years, so F0 E5 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
F0 E5 means a Maytag washer has detected an off-balance load, which lowers spin speed and can leave clothes dripping wet.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Maytag appliance?
Book a specialist visit for a clear estimate and approval before any repair.
F1 E1 is a main control (ACU) fault on front load Maytag washers; top load listings give no cause. Unplug for 5 minutes, then book a visit if it returns.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Maytag appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
