Written by
Tessa Brandt Appliance Care EditorPublished October 29, 2026
VERIFIED
Error codeF3E2
ApplianceDryer
The front moisture sensor strip
Maytag’s dryer service data sheet defines F3E2 as an open or shorted front moisture sensor strip. It appears in service diagnostic mode only, so it is not something normal use puts on the display.
What an owner can look at
Maytag’s help page for the display message lists two checks worth making if the dryer is not sensing moisture properly.
Check that the dryer is level. A dryer that leans may keep clothes from touching the moisture sensors.
Check the load. Very small loads and single items can miss the sensors, so dry larger loads or use an Automatic cycle rather than Timed Dry.
The help page also lists a power reset: breaker(s) off for 1 minute, back on, then a time dry cycle with 1 minute of monitoring. Testing the strip itself is a technician’s job.
F3 E2 is the display message about no moisture sensor data.
F3 E5 is a second sensor data message, raised after five loads.
Moisture sensor repair in San Francisco
For sensor strip work on a Maytag dryer in San Francisco or the Bay Area, call (415) 649-2156. Give the technician F3E2, the model number and any steps from the list above that you tried. The Maytag dryer repair page has the details.
Model compatibility: Maytag reuses codes across series and model years, so F3E2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
Front moisture sensor strip open or shorted; shown in service diagnostic mode only.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Maytag appliance?
Book a specialist visit for a clear estimate and approval before any repair.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Maytag appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
