Written by
Tessa Brandt Appliance Care EditorPublished October 29, 2026
VERIFIED
Error codeF20
ApplianceWasher
F20 in one line
A front-load Maytag washer that shows F20 is short of water. Maytag classes it as a water inlet problem, either no water arriving or an insufficient supply.
Supply checks, then a reset
Both the hot and the cold faucets must be turned fully on.
Inspect the water inlet screens for clogging.
Look over the inlet hoses for kinks.
Unplug the washer for 5 minutes, then plug it back in and watch the display. Maytag says a control reset can sometimes clear a fault, much as restarting a computer does.
If F20 is still there after all four, a technician visit is the next step.
Do not confuse F20 with
F21, which is about draining, the opposite direction.
F3 E1, where the washer cannot detect the water level.
Maytag washer repair across the Bay Area
Water valves open, screens and hoses fine, and F20 still showing? (415) 649-2156 connects you with our San Francisco Bay Area team for Maytag washer repair. Say which of the checks you completed and read out the model number.
Model compatibility: Maytag reuses codes across series and model years, so F20 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
F20 on a front-load Maytag washer indicates a water inlet problem: no water or an insufficient water supply.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Maytag appliance?
Book a specialist visit for a clear estimate and approval before any repair.
A front-load Maytag washer uses F3 E2 for a pressure system fault, whereas top-load models may be showing hot and cold hoses installed the wrong way round.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Maytag appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
