Written by
Tessa Brandt Appliance Care EditorPublished October 29, 2026
VERIFIED
Error codeF3 E2
ApplianceWasher
The meaning of F3 E2 changes with the washer. Pick the layout that matches yours.
Front-load washers
Maytag calls it a pressure system fault: the pressure signal is out of range or absent. The listed owner step is the 5-minute power reset.
Top-load washers
Maytag says the code could mean the hot and cold inlet hoses were put on incorrectly. The telltale sign is a cold hose sitting on the hot inlet while the hot hose sits on the cold one.
Match each hose to its inlet: cold belongs on cold, hot on hot.
Turn both water valves fully open, and confirm that each inlet hose is attached.
Unplug the washer for 5 minutes, plug it back in, and see what the display says.
The tech sheet’s separate F3E2 entry asks for the same valve and hose check. A code that does not clear means a technician visit.
Hoses sorted and valves open but F3 E2 persists? Our team does Maytag washer repair in San Francisco and around the Bay; the number is (415) 649-2156. Say if the washer is a front or top loader, and give the model number along with the checks you made.
Model compatibility: Maytag reuses codes across series and model years, so F3 E2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
F3 E2 is a pressure system fault on front-load Maytag washers and can mean crossed hot and cold inlet hoses on top-load ones.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Maytag appliance?
Book a specialist visit for a clear estimate and approval before any repair.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Maytag appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
