Maytag Microwave D1:0 Error Code
D1:0 and D1:1 are setting readouts on a Maytag countertop microwave, showing whether the 2-step door is enabled.
Model Reference
Maytag MMV6190FZ Microwave Repair
An over-the-range 1.9 cu ft convection microwave, tested in your kitchen.
- 8appliance guides
- 50model pages
- 561error codes explained
- 150Bay Area places
- Mon–Sat8:00 AM – 7:00 PM
Model number
MMV6190FZ
About this model
Model overview
The MMV6190FZ is an over-the-range microwave at 1.9 cu ft with convection, and it is still sold new. A convection microwave adds a heater and a fan for the oven mode, so there are more parts that can fail than in a basic unit. For general background see Maytag microwave repair and Maytag microwaves.
Symptoms that bring owners to us
Common reports are a microwave mode that works while the convection mode does not, a display that stops responding, a unit that shuts off mid-cycle, a light that stays dark, and a fan that does not clear steam. Treat these as separate problems, because each has a different suspect behind it.
Codes that fit a convection unit
F3T2 points to the convection thermistor or its wiring. F3C points to the cavity temperature thermistor. E23 refers to a heater, the control board or the wiring. We use the code to decide where to test first.
Mounting and ducting
Over-the-range microwaves are bolted to the wall and the cabinet above, and often the weight of a convection model strains a mount that was set for a lighter unit. In Bay Area rentals we see mounts that have loosened over time and ducts that were left disconnected after an earlier swap. We check the mount, the duct path and the power connection before blaming the electronics.
Owner steps
- Confirm the breaker is on and cycle it once.
- Wash the grease filters.
- Make sure the door closes and the turntable sits properly.
- Note the mode that fails: microwave, convection or fan.
Stop using it if you see sparks or smell burning, and switch it off at the breaker. Never open the case.
Number check
Its neighbors are the MMV1175JZ and the MMV4207JZ. The numbers look similar, and a single letter off changes the parts. Our guide on how to find your Maytag model number may help if the label is hard to read.
How we proceed
We diagnose first, explain the result in plain language, give a written estimate, and repair only what you approve. If the problem turns out to be the mount, the duct or the grease filters instead of the electronics, we say that too, because the simplest fix is the one that matches the real fault.
Frequently asked questions
It has a heater and a fan beyond the standard microwave parts, so there are more parts that can fail.
The two modes use different parts. A technician checks the convection heater, fan and sensors separately.
No. It points to the convection thermistor or its wiring, a specific area to test.
A loose mount can cause vibration, so we check it along with the unit.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Diagnostics
Error codes for this appliance
Fix it right
Repair service
Microwave Repair in San Francisco
Over-the-range Maytag microwave repair in San Francisco and the Bay Area, from no-heat faults to vent fans, door latches and display codes.
Models
Other models
Book a repair
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Phone
(415) 649-2156
Hours
Mon–Sat: 8:00 AM – 7:00 PM
Service area
San Francisco Bay Area, California