Written by
Tessa Brandt Appliance Care EditorPublished October 29, 2026
VERIFIED
Error codeF8 E6
ApplianceWasher
Two meanings, depending on the model
Maytag gives F8 E6 two explanations for top load washers, and which one applies depends on the machine.
The lid was left open during the soak cycle. Close it and the cycle carries on.
The washer found no hot water, which is where the plumbing checks come in.
If hot water is the issue
Hoses on the wrong valves
The code can mean the inlet hoses were put on the wrong way: the cold hose is on the hot inlet and the hot hose on the cold inlet. Swap them over and start another cycle.
Valves and connections
Open both the hot and the cold valve all the way. Both inlet hoses must be attached for the washer to work as it should.
Reset as a last step
Leave the washer unplugged for five minutes, then plug it in and watch the display.
Related water codes
F20 is a water inlet problem, with no water or too little.
F3 E1 means the washer cannot detect the water level.
Washer service for F8 E6 in San Francisco
When the lid is down, the hoses are on the right valves and the code still shows, a technician visit comes next. Call (415) 649-2156 for Maytag washer repair in San Francisco and the Bay Area. Mention the model number, the code, and which hose and lid checks you finished.
Model compatibility: Maytag reuses codes across series and model years, so F8 E6 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
F8 E6 on a top load washer means either an open lid during the soak cycle or no hot water detected.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Maytag appliance?
Book a specialist visit for a clear estimate and approval before any repair.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Maytag appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
