Maytag Ranges

A Maytag range does two jobs in one cabinet, and in a San Francisco kitchen it usually does them in very little room. Galley layouts in flats, narrow Victorian kitchens that were chopped into units, and in-law apartments with a single wall of cabinets all put a freestanding range between a refrigerator and a countertop. When something fails, you notice at dinner time: a burner that will not light, an oven that stops short of its set temperature, a door that stays locked after a clean cycle. Our Maytag range repair visits start with a diagnosis, and you get a written estimate before any part is replaced.

The ranges we see most

Five Maytag range models are in our reference list, split between electric and gas. All five are 30″ freestanding ranges.

• MER6600FZ: an electric range, 30″, 5.3 cu ft.
• MER8800FZ: an electric range, 30″, 6.4 cu ft with true convection.
• MFES8030RZ: an electric range, 30″, 5.3 cu ft with Grill Mode.
• MGR6600FZ: a gas range, 30″, 5.0 cu ft with a fifth oval burner.
• MGR8800FZ: a gas range, 30″, 5.8 cu ft with true convection. It is no longer sold new, but it is still serviced.

Finding the model label

On a freestanding range the label is usually on the frame around the oven opening, so it shows when the oven door is open, or on the inside edge of the storage drawer opening. Photograph the whole string, letters and digits, so we know the fuel type and the parts involved.

What goes wrong most often

Oven that will not reach temperature

A bake or broil element that has stopped working, a temperature sensor that reports the wrong reading, or a control that no longer commands heat can each look like a cold oven. Our guide to an oven that is not heating explains how the symptoms differ, and the one on an oven temperature that is off covers food that cooks too slowly or burns even though the display looks normal.

Burners that click but do not light

On a gas range the cause is often grease or boil-over residue at the burner ports, or a spark module that has stopped producing a steady spark. Read what to look at when a gas burner will not light before you try matches.

Door and lock trouble

A latch assembly or switch that cannot confirm the door position stops a self-clean cycle or leaves the oven unwilling to start. Banging on the door does not help and can bend the latch.

Codes your range may show

Maytag range displays use letter-number codes, and our reference list gives plain meanings for the ones we have verified. A few examples: 1d11 points toward the oven temperature sensor, the control or the wiring. 4d11 points toward the oven door latch assembly, the door switch or the wiring. 4d21 refers to an airflow restriction, the oven cooling fan or the wiring. F5 and the F1-A family refer to latch and lock problems, and F9E0 mentions mis-wired house or range power. A code names the area to examine; it does not name the failed part. Our full range error codes guide lists the rest.

Safe first steps for owners

1. Write down the code exactly as shown, then note what you were doing when it appeared.
2. Check that the breaker for the range has not tripped, and that the plug or outlet area looks undisturbed. Do not pull the range out to look behind it.
3. For a gas range, confirm the gas valve position and wipe cooled burner caps so they sit flat.
4. Make sure the door closes fully and that nothing is caught in the gasket.
5. Try one controlled power reset at the breaker, then restore power and see whether the code returns.

If you smell gas, leave the home, avoid switches and lights, and call the gas utility or 911 from outside. If you see sparks or smell burning, turn the range off at the breaker and leave it off. Never open panels or touch gas fittings yourself.

Installation details that change the diagnosis

An anti-tip bracket should hold the rear of the range to the floor or wall, and a technician checks it whenever the range has been pulled out. Gas supply connections, the flexible connector and the shutoff valve all sit behind the range, so we confirm them as part of any gas burner call.

Next steps

When you are ready for a visit, our range repair service page explains how the appointment runs: the technician diagnoses first, you receive a written estimate, and nothing is repaired without your approval. If you also have a built-in oven or a separate cooking surface, see Maytag wall ovens and Maytag cooktops.

Frequently asked questions