Written by
Tessa Brandt Appliance Care EditorPublished October 29, 2026
VERIFIED
Error codeF6 E1
ApplianceWasher
What F6 E1 says, by washer type
Front load: a communication error. The HMI, the user interface, cannot hear the ACU, the main control.
Top load: Maytag shows the code with no cause attached, only reset and service steps.
The single owner step
Whichever type you own, the advice is the same: give the control a power cycle.
Pull the washer’s power for 5 minutes; for a plugged-in washer, that is the plug.
Put the power back.
Watch the display to find out whether F6 E1 returns.
Where to look next
F6 E3 is the communication error on the other side of the control, the ACU failing to hear the MCU.
F6 E2 is listed with reset and service steps for front load washers.
F5 E1 is a different matter, the door or lid switch.
Maytag washer repair in San Francisco
A communication fault between boards cannot be fixed with the reset alone if it returns, and then it is time for a technician. Customers in San Francisco and the Bay Area can phone (415) 649-2156. State the code, say if the washer loads from the front or the top, and read out the model number. See Maytag washer repair too.
Model compatibility: Maytag reuses codes across series and model years, so F6 E1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
Communication error: the HMI cannot hear the ACU (front load); no cause stated for top load.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Maytag appliance?
Book a specialist visit for a clear estimate and approval before any repair.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Maytag appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
