Maytag MHWZ600TW Epic Z Washer Repair

An older Epic Z, still in service

The MHWZ600TW is a Maytag front load washer from the Epic Z 3.7 cu ft series, and it is no longer sold new. That is the whole of what we claim about its construction. A machine in this position tends to be on its second or third owner, or in a rental where it has been quietly doing the job for a long time.

Repair or replace: what actually decides it

Because the model is discontinued, the first practical question is whether the needed part can be sourced. We check that during the estimate rather than guessing from the age of the machine. The decision then comes down to what failed: a drain pump or door lock is a different conversation from a failed main control or a leaking tub.

Faults we see on aging front loaders

• Door gasket tears or mold build-up that lets water seep onto the floor.
• A drain that empties slowly, with lint and small items in the pump area.
• Noise during spin, which may be a worn bearing, a load issue or a machine not level on the floor.
• Motor or drive codes that appear mid-cycle.

Reading codes

Motor-speed trouble is described under F7 E1, while an off-balance condition is F0 E5. A long drain is F9 E1. Different codes can have a simple cause such as an uneven floor, so we confirm the cause before quoting a part.

Floors and closets in older homes

Hardwood floors in older San Francisco flats flex, and a front loader spinning at speed will find every soft spot. A machine on a raised platform in a garage may have uneven feet instead. Levelling and a hard look at the hoses take no effort to check and settle many noise complaints.

Safe things to do first

• Switch off power and shut the supply valves if there is a leak.
• Clear the drain filter if you can do it without forcing anything.
• Leave the door open between loads so the gasket dries.
• Do not take panels off.

Read more about the type in our overview of Maytag washers, and about the work in Maytag washer repair. We give a written estimate before repairing and do nothing without your approval.

Keeping it going

A discontinued washer rewards routine care. Wipe the gasket, leave the door ajar and keep the drain filter clear.

Frequently asked questions