Maytag MTW7205RF Pet Pro Agitator Washer Repair

Know the difference from a close relative

The MTW7205RF is a top load Maytag washer, Pet Pro agitator, 5.2 cu ft, currently sold. A neighboring Pet Pro model uses an impeller, so confirm the full number on the label before ordering any part or booking a repair. One digit apart can mean a different drive system. More models are collected at Maytag washers.

Typical complaints

With an agitator washer the first question we ask is whether the agitator itself moves.

• Agitator does not turn but the tub spins, or the reverse.
• The cycle pauses with a full tub and nothing happens.
• The washer fills only part of the way.
• Squealing or thumping during spin.

Diagnosing in order

A technician starts with what is cheap to confirm: power, supply valves, lid switch and hoses. If the washer fills slowly, Maytag washer not filling lists the common causes, and if the spin fails, Maytag washer not spinning gives the sequence. Only then do we move to the drive and control.

Codes

Examples tied to this kind of washer include F8 E1 for a slow fill, F20 for no or low water inlet and F21 for a drain problem. Your display may show a shorter code; either way, write it down exactly.

Garage and closet installs

In Sunset and Richmond garages a washer often shares space with storage boxes that push against the hoses. In a flat, a hall closet may leave the hoses tight to the wall. Either way, a quarter-turn of the supply valve and a straight drain hose often change a symptom.

Small things that matter

• Do not overload the tub.
• Keep detergent measured.
• Leave the lid up between loads if smells linger.
• Never put your hand in a moving tub.

We diagnose first, give a written estimate and wait for your approval before doing any repair. For the service overview see Maytag washer repair.

Questions worth asking before the visit

Is the washer quiet but not moving the agitator? Does it hum? Did it recently run an unusually heavy load? Short answers like these save time on site, because they point the technician toward the lid, the drive or the load itself. If you have owned the washer a long time, mention any earlier repairs too.

Frequently asked questions