Maytag Washer CL Error Code
CL on a Maytag front load washer is not a fault: it reminds you to run the Clean Washer cycle.
Model Reference
Maytag MVWX655DW Bravos X Washer Repair
Bravos X owners usually come to us with a washer that quit in the middle of a cycle.
- 8appliance guides
- 50model pages
- 561error codes explained
- 150Bay Area places
- Mon–Sat8:00 AM – 7:00 PM
Model number
MVWX655DW
About this model
Model overview
Where the MVWX655DW fits
The MVWX655DW is a top load Maytag washer in the Bravos X series, no longer sold new. We have no capacity or size for it and do not supply any. Other Bravos washers are listed under Maytag washers.
Mid-cycle stops
The most common reason a washer quits partway is that it detects a problem and holds. The three questions we ask are: is the lid reading as closed, is the water at the right level and is the load balanced? Each has a short owner check and a deeper technician test.
The deeper tests
- Lid switch and lock: tested with the lid in several positions.
- Water level system: whether the control sees the tub filling.
- Drain pump: whether it runs and moves water.
- Drive: whether the motor and coupling respond.
Related codes
Entries that relate are LdL for a lid that will not lock, LF for a long fill and Ld for a long drain. A bare flashing light without a code is also information; tell us about it.
Tips by housing type
In a studio with a washer inside a kitchen closet, shared walls make noise travel, so you may notice a drive problem earlier than in a garage. In a garage the opposite applies: a failing part can go unheard for weeks. Hoses behind the washer are often the first thing that has been bumped.
What not to do
- Do not run it again and again after a repeated fault.
- Do not reach into a moving tub.
- Do not pry the lid lock.
The write-up for Maytag washer lid lock flashing covers what to expect.
Booking
Visit Maytag washer repair for the process. We diagnose first, give a written estimate and do nothing without your approval.
Expectations for an older machine
Older washers have usually seen more loads and more moves. A technician expects to find some wear, such as a stiff lid hinge or a tired hose, and says so plainly. We list what is worth repairing and what is merely cosmetic, so the estimate reflects the actual condition of the machine in your home, the way it has been used and the way it was installed, and not a general idea of the model.
When you book, describe the washer symptom, any noise or leak, and whether a code appeared, so the technician arrives knowing where to start.
Frequently asked questions
They are separate series. The label number tells us which you have.
It is no longer sold new.
Count and describe the blinks when you call; we use that along with the symptom.
Frequently yes. We check the fault and part sourcing during the estimate.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Diagnostics
Error codes for this appliance
Fix it right
Repair service
Washer Repair in San Francisco
Top-load agitator, impeller and front-load Maytag washers repaired across San Francisco and the Bay Area: drain, fill, spin, lid lock and balance…
Models
Other models
Book a repair
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Phone
(415) 649-2156
Hours
Mon–Sat: 8:00 AM – 7:00 PM
Service area
San Francisco Bay Area, California